Polaris Ranger 1000 SOHC Bottom End Refresh Kit 2020-2023

Description

Refresh Kit for the 2020–2023 Polaris Ranger 1000 SOHC Bottom End

This Ranger 1000 SOHC refresh kit supplies the chains, bearings, gaskets, and seals listed below. It fits 2020–2023 Polaris Ranger 1000 models equipped with the SOHC engine.

This package does not include a crankshaft, connecting rods, pistons, or a cylinder. Therefore, inspect those components before choosing between a refresh kit and a larger bottom-end rebuild package.

This Kit Includes

• Timing Chain
• Oil Pump Chain
• Rod Bearings
• Main Bearings
• Balance Shaft Bearings
• Complete Gasket and Seal Kit

Bearing Numbers Required

Send REV6 your block, rod, and crank numbers. Our team can then mark the correct bearing specifications for easier installation.

Because bearing selection depends on those identifying numbers, do not rely only on the model year when preparing your order.

Refresh Kit or Complete Bottom End Rebuild Kit?

Choose this refresh kit when the crankshaft, connecting rods, pistons, and cylinder remain reusable. If inspection shows that your project requires additional bottom-end components, compare the Polaris Ranger 1000 SOHC Complete Bottom End Rebuild Kit.

You can also browse the 2020–2023 Polaris Ranger 1000 SOHC engines and parts category for related top-end, bottom-end, and full-engine kits.

Warranty and Bearing Support

REV6 backs this kit with a 1-year parts warranty. Review the REV6 parts warranty for coverage information.

If you need help locating your bearing numbers or comparing rebuild levels, contact the REV6 team before ordering.