Polaris 800 2008 – 2015 Break-in Procedure
RMK, Dragon, Pro, Assaolt etc. All CFI models
RMK, Dragon, Pro, Assaolt etc. All CFI models
Engine Break-in
You must run one full tank of fuel through your new Rev6 engine in order for the break-in to be completed.
● Add 16oz of 2 stoke oil to a full tank of gas for the first initial break in.
● Make sure all air is bled out of the cooling/oil system.
● Do not let machine idle to warm up! Drive sled slowly until operating temperature.
● Very throttle positions for non- maintained speeds.
● Do not hold the throttle open longer than 7 seconds until the break in is completed.
● Do not mix oil brands.
Break in on these engines is Crucial! proper break-in can result in better performance and life for your new engine.
Warning!
● DO NOT idle your engine for warm-up.
● Excessive idling can result in immediate engine failure.
● DO NOT idle engine for longer than 1 minute at a time.
● Drive machine at low rpms until operating temperature is reached.
● This process must be followed for life of the engine.
Ski-Doo 800R E-Tec, P-Tek 2007 – 2016 Break-in Procedure
You must run one full tank of fuel through your new Rev6 engine in order for the break-in to be completed.
● Add 16oz of 2 stoke oil to a full tank of gas for the first initial break in.
● Make sure all air is bled out of the cooling/oil system.
● Do not let machine idle to warm up! Drive sled slowly until operating temperature.
● Very throttle positions for non- maintained speeds.
● Do not hold the throttle open longer than 7 seconds until the break in is completed.
● Do not mix oil brands.